Product Search  
News Center
   Company news Home > News Center > Company news

Process requirements for welding gloves

Source:  Date: 2019-03-21  Reads: 497


(1) Welder glove structure: The seam of the welder's glove and the back of the hand should be set with a strip of leather. The slats should be chrome-tanned or pigskin. The leather and the reinforced skin should be the same leather as the palm and the back of the hand. The reinforcing liner has a width of 15 mm or more.


(2) Welder gloves stitch code: 3 to 4 needles per cm for the bright line; 4 to 5 stitches per cm for thedark line.


(3) Sewing of welder's gloves:
the hand shape should be positive, the seams should be straight and flat, thestitch length should be well-proportioned, and the tightness should be
moderate. If a broken needle, continuous leak or jump is found, the needle should be re-stitched or the defective stitch removed.


(4) Welder glove size: Theminimum size of the welder's length and width shall comply with the regulations. The length (L1) refers to the distance from the fingertip along the back of the middle finger to the glove cuff; the length (L2) refers to the distance from the fingertip along the back of the middle finger to the seam sleeve; the length (l3) indicates the glove sleeve. Length; width (c) refers to the distance from the outside of the base of the little finger to the outside of the root of the index finger. In order to ensure that the dimensions measured from the various welder gloves are comparable, the gloves should be flattened before being measured. For special shape welder gloves, the size is determined by the supplier and the buyer.


(5) Welder gloves suture:
welder gloves sutures require uniform and no scars, single line strength is greater than 22.54N/50cm.
Copyright HANGZHOU DONGDI IMP&EXP.CO.,LTD | All Rights Reserved
Tel: 86-571-85386671,85386672,85386673 Fax: 86-571-85386676
Http: E-mail:

浙公网安备 33010302003203号